Salamander TankBoost 100L Mains Pressure Boosting Tank (TNK-100-SUB)

Do you have a question about the Salamander TankBoost 100L Mains Pressure Boosting Tank (TNK-100-SUB)?

Click the button below to send a question to one of our expert members of staff and we will email you back a direct response. If we feel the information might be useful to other customers, we will also show your question below for others to see.

Ask a Question

• Where can TankBoost be installed?

  "The floor/mounting surface (supporting TankBoost) must be flat and level, fully supporting the unit. It must be able to withstand the maximum full weight of the TankBoost unit (please refer to the technical specification for the weights of each unit). Additional supports should be added to support surface/unit' if required. TankBoost will fit perfectly in a garage or utility room. "

• What pipework connections does the TankBoost have?

  All TankBoost units have a ½” brass male inlet connection and 1” female outlet. It is recommended to have 28mm diameter pipework from the TankBoost so as not to restrict the potential flow rates from the unit. This can then be reduced to 22mm or 15mm pipework closer to the outlets.

• Can you use TankBoost to pump hot water?

  No, TankBoost has been designed for cold water only, it can however be used to increase cold water flow rates and pressure to any mains hot water system such as unvented cylinders and combi boilers.

• Can TankBoost be used on combi boilers and unvented systems?

  Yes, TankBoost is ideal for delivering pressure and the higher flow rates required to unvented systems up to 80 litres per minute. TankBoost can also be used to supply combi-boilers, however, combi-boilers may restrict the flow rate of hot water that can be produced.